Recent content by Stealthe

ive installed dozens of hopper/joey systems and have not had a problem doing downloads on multiple joeys at a time as long as hopper has fully downloaded with Client ID...if this is causing people issues the problem is likely elsewhere...unfortunately Dish greatly underestimated multiple hopper...

The tech have meant you would have better los closer to the house...the eastern arc signal is not "less" than western arc...mpeg4 simply requires less signal

77 is only used for some locals and dish latino...The sattelites on installation screen mean nothing as far as install goes dont worry about that.After running checkswitch if pointed properly you should see 61 and 72...the downloads come from 61 so you can still do downloads but many channels...

You can use a sling link adapter for VIP reciever to hook it up to the Internet as it uses home wiring to distribute the signal. You can use a Phonex Easyjack 2 to transmit your phone line through the electrical wiring. You can also use dishcom modem to transmit phone line through electrical...

It is very likely dish will have LOS as they have 2 arcs to choose from.However the high def 129 has a low 30 degree elevation which can sometimes be a problem.The eastern arc however points ruffly 45 degrees to the left of the western arc and its lowest elevation orbital is 61.5 at 36...

There never goin to be exactly the same.Im not sure what there -/+ is for the inputs but most electronics are at around -.5/+.5 so that variance should definetly be fine.But the voltage being fine doesnt justify the reciever nput is good.The input has to be bad

It will work.You will need to activate the new recievers,setup the new remote controll addresses and set the remotes up to work with the TV's. TV2's may not be on the same channel anymore. To be sure they do go into the menu to 6-1-5(modulator setup) Make sure the the new reciever has the...

Nope.It would be the same as running 2 line directly from the LNBF.It doesnt care what input it goes in.It should work in either. However it does not work to run 2 single tuning boxes off a seperator cause there is no DPP single tuner(just a side note) but if your running to a dual tuner its...

make sure you do hard reset and then try and if still the same its the reciever

it would have to be the reciever.If you ran a direct line to Input 1 from the LNBF and got nothing and it worked on port 2 it has to be the reciever

Problems in the line can just as easily cause this.Just yesterday I fixed this issue with a customer as they had a low frequency barrel in the line that eventually began to burn out.Here is a list of things to check for as they can be the problem. -Low frequency barrel -RG59 coaxial cable...

Some power saving newer tv's give off an IR signal through the room to detect lighting and adjust screen brightness accordingly.This IR signal does effect some UHF signals. Try disabling "Dynamic Contrast" or disable the "energy saving" option if equiped. Or move antenna THE EXTENDED ANTENNA...

Using an I bracket your getting prime focus.With a y you have an offset giving you less gain

Good luck

Why do you think there is a problem.Are you missing channels.