Recent content by t0n3dawgg

I am planning on taking the receiver to the motor or the motor to the receiver and connect with short jumper coax this weekend since that would be the best time at the moment, but I will give you guys a update ASAP. I also emailed the person I brought it from and he said that if it still...

Wouldn't that mess up the motor? someone posted before that it should be set to zero before resetting it.

Alright I just came back from circuit city and got 2 cables of RG6.... still no luck. Damn! I just narrow it down to its either the coolsat or the motor. Where would I go to get warranty for the motor? Could it be a coolsat problem?

1. The switch works 2. The yellow/orange changes for about a good second before going back to green when I reset it. 3. Took out the DiSEqC switch 4. Haven't try the tv yet. (Will try, but will be last resort.) 5. Going to try as soon as I buy some "RG6" cable. Do you happened to know if...

1.The led doesnt' change (stays green) when I have my friend holding on move. 2. I wasn't able to see when i reseted it if it turned orange because there was too much light out. 3. I took out the DiSEqC switch and went coax straight to the coolsat. 4. I don't want to bring the motor down...

I think I may have to buy one because the one i have now is too short to cut. Meaning if I was to cut it any more it wouldn't be able to reach my coolsat. I hope its a cable problem and not a motor problem has I just barely got the motor :( , but thanks for the help so far!

Disconnected the wire from LNB to motor and still no luck. Could there be a problem with the cable that goes to motor to coolsat?

I'll try that now :)

No lucks guys. :(

I tried both USALS and DiSEqC and had no luck. I'll try the reset tomorrow Tron. Its already dark here and I don't want to fall off the roof :D Thanks again for the help!

Sorry for the late reply guys I haven't had time to play around with it, but here the update. The LED is green when the coolsat is on and when I move it from the inside my friend tells me it is still green, but doesn't move. I haven't tried to play around with the wires yet, but I don't see what...

I'll give it a look when my brother gets home so I can stand outside and stare at the motor

That's how I setup my FTA. "my motor acted strange today like it didn'y have power so i powered down undid my coax and reconnected . and repowered and it worked" I tried it the first time didn't work. I'll try it again. You guys think the cable went bad? I still can watch tv, but i...

Yeah, it's outside. Is that a bad thing? But even without the switch it still won't move :(

First I did LNBF -> Switch -> motor->coolsat Then I took out the switch and still no luck. I alway turned off the coolsat by the back buttom. Oh sorry psb. I"m using MOTECK