Recent content by twofour

Yes You are correct I confused Ultra with Platinum sorry about that

VS Ultra blind scan does not work it will not find anything You have to plug in Known transponder info The Xstreme blind scan is hardware based and works well I learned the hard way.

Mine did that a while ago and it never recovered ; never recovered. Tried to find parts, even emailed stabb no luck. If you manage to fix yours please let me know as mine is on the shelf in the basement for last 6 months. I need the positioner board as the motor is fine.

It must support goto x Ihave a motor a Digiwave HH-990 does not work in usals. Tried with Fortec Ultra, Pansat 2500, and Viewsat Xtreme. Stab HH-90 works with thease.

Well that would be the hard way I would get a short piece of RG6 and connect it to the motor and the viewsat on the ground, or in the house and then using a TV and the receiver and the motor all connected (No lnb of course) goto antenna setup>>goto motor and select installer, then press OK...

Make sure the motor works before u mount it

To set for Usals goto antenna setup >> motor scroll to USALS push enter and use arrow keys to set long and lat. it will drive that motor.

Well if you get it to move after you do that (cycle the hard power switch on the stb after first before you send any move commands) then set the motor to zero position manualy, and reset it again, to zero it. You will loose any diseqc memory settings, but usals should not be changed. Mine got...

Try pushing the reset and holdind you figer on the travel button at the same time

I have a viewsat extreme with a cheap motor attached. I thought the same as you when my stab motor bit the dust shortly after swaping out my Pansat 2500 with the viewsat. But what I found was a bad cable that was getting wet when it rained and was slightly corroded, I changed it out and...

Anyone know if there is a parts supplier. I need the electronics

Yes I tend to agree as I belive the VS killed my original Stab HH 90 of witch I was very happy with. But I did not want to spent the money for another one just incase the VS smokes it also. Sofar it is doing quite well with this motor in Disecq mode. and it has not seemed to lose any memory...

Thanks for the reply, but Yes I have checked that, and tried setting to "00" to clear. I would like to know if anyone has this motor working in usals mode. maybe that is why it was so cheap!

I have a VS2000 extreme with a Digiwave HH990 dish motor when I try to drive the motor in usals mode it will not move DiSEqC mode it works Quite well should it not also work under usals mode. I also have a pansat and it does the same thing I am confused as the motor claims to have "goto x"...