Recent content by vianello.elec

Replaced power supply and everything good. Sent from my SM-G930F using Tapatalk

The power supply was pushing out a irregular square wave which was interfering with the voltage to the lnb causing no feedback signal, which my meter was buffering if that makes sense. Sent from my SM-G930F using Tapatalk

It's fine....i solved the problem. Thanks anyway. Sent from my SM-G930F using Tapatalk

Really....i have time for jokes Sent from my SM-G930F using Tapatalk

It is a sentech satelite receiver connecting to is20 in the eutelsatsat group working with a 80cm dish with single universal lnb Lo 9.7 to 10.6 ghz.. is this not the right group? Sent from my SM-G930F using Tapatalk

Basically a new installation that worked and am trying to repair. Sent from my SM-G930F using Tapatalk

Single sentech new receiver, rg6 coax about 20 meter long with no splitters. Sent from my SM-G930F using Tapatalk

If the meter is connected in series to the receiver....all works fine, I can watch all the channels with full signal....if I remove the meter then I have no signal and can't view anything.The dish is aligned perfect, I even swopped dishes and lnb. Sent from my SM-G930F using Tapatalk

But if I take the receiver to another satelite dish it works, with the same readings on the meter but without the meter. Sent from my SM-G930F using Tapatalk

No...i disconnect the f type from the lnb and connect to the meter and use a outperform the meter to the lnb. Sent from my SM-G930F using Tapatalk

Satelite reciever Sent from my SM-G930F using Tapatalk

Hi...has anybody experienced full signal on the satfinder, but then no signal on the decoder. However if you connect the satfinder in series with decoder, all works fine with full signal...the meter is a first strike. Any advice is well come as I have swooped out decoder and dish already. Sent...