Recent content by vining

I have an Acutract III+ w/ the following readings. I'm new to the MPEG4 systems (AU9 & H23's) and I need to verify my signals are ok, primarily the 49.3 reading when the meter's in the KA 103 & KU 110/119 mode. Is this an acceptable level in this meter mode. TIA! Meter Setting KA 99 & KU 101...

Got an email from the home owner and they are h23's so according to the thread on h23's no BBC required. So If I pull the diplexers out again and run straight from the dish's integral switch straight into the H23 receiver with the signal levels posted early in this thread using my Acutrac...

iwc5893 wrote: AU9. Jimbo wrote: Hmmm. I don't even know what type of receiver they have, I'll post when I figure that out. The Pics on the website aren't distinct enough for me to tell. What's a BBC module? These receivers were installed by the direcTV guys doing the conversion but since...

RG-6 has approximtely 6db of loss per 100' but that loss gets higher as the frequency gets higher so RG-11 woul dbe much better but you then need RG-11 connectors and a crimper to make your terminations. The amplifier you listed prior sounds pretty good and compensates for tilt (higher...

I haven't touched a dish in years but since the local directv guys doing the 5lnb mpeg changeover wouldn't install the dish (just dropped it off with the homeowners) I was recruited to do the install since I do their AV. I have an AcutracIII+ meter with the following levels: Meter Setting...