Search results for query: *

Thanks. Apparently that wasn't the issue. I do indeed have a 6x8 multiswitch hooked up, and I did the forced update. Still getting the pixelation. Considering the only time I got the pixelation to stop was when I had the two lines hooked into the receiver, that's gotta be it - right? So I...

Can you please explain what you mean here? Also, how do I know if I have a 4x8 or 6x8?

Yes! I actually came on here to troubleshoot this very problem. I believe you are correct - I believe that the HR21 DOES require 2 Satellite ins in order to run properly. I have 4 lines run to my entertainment center in my basement and 4 HDTVs. I recently got 2 HR21s - one for my big...

Thanks for the info, Raoul. Much appreciated. Will I need an active Access Card in the Dtv receiver? I shouldn't since I'm not even hooking it up to the dish, right?

I just purchased 3 H20's last week, all for the same entertainment center which houses 3 televisions. According to what was explained in some of the posts below, they must be 600's because of the lights. 2 of them seem to be working fine. Last night though, the one that controls one of my top...

Question for the experts out there.....you were so helpful when I was purchasing/installing my equipment a few weeks back I thought I'd ask for assistance on another matter. I am trying to help my dad set up High Definition for his new television. They bought a 45" Sharp Aquos LCD that does...

Thank you for the response. I am surprised by this....the jacks are labeled (from left to right) 18V-13V-18V-13V-FlexPort 1-Flexport 2. Underneath the two left-side jacks (18V and 13V), it says Sat 99/101 degrees. Underneath the middle two jacks (18V and 13V) it says 22 KHz 22 KHz and...

Ok, thanks for the advice. It does help, greatly. I am having someone come out and install my dish, hopefully later this week. I have my cabling pretty much all set. My only other question right now is....which 4 (of the 6) inputs on the WB68 do I use, and does it matter where those inputs...

Hello all, new poster here. I was hoping someone could give me a bit of guidance. I've done Dtv installations on my own in the past probably 5-6 times, but it was always with a single or dual lnb standard dish. I have just upgraded to the AT9 and some H20 receivers, and I need some help...