Search results

  1. A

    PAUXIS C-BAND ONE CABLE SOLUTION LNBF Model PX-2000 200K

    ---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- Thanks Titanium for your prompt reply and help You...
  2. A

    PAUXIS C-BAND ONE CABLE SOLUTION LNBF Model PX-2000 200K

    Reference to the above subject The salesman told me that above lnbf with 200K Noise Temperature is the best for receiving HD FULL HD 1080 MPEG4 -S2 TV channels . But from my previous knowledge the better low noise temperature in K kalvin is the better , therefore lnbf with 15K or 17k is...
  3. A

    How to determine the elevation angle of Offset dish

    Is this formula is correct blelow :- The elevation angle of offset dish = The elevation angle of prime focus dish - offset angle of offset dish Example :- the offset angle of the offset dish from Dish fatory = 20,36 deg. fixed angle The elevation angle of prime focus dish = 61,21 deg...
  4. A

    Does extending a coaxial cable degrade signal?

    ------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- To- Titanium what say it is correct But when comes to...
  5. A

    Does extending a coaxial cable degrade signal?

    The Maximum cable Length between Receiver and LNB NOT more than 25 Meters ( 82 feet ) This is the maximum cable length you can get . More than that, week signals will be degraded .
  6. A

    Xtrend ET 10000 Quad G-Edition Linux VLan PVR Receiver

    Thanks Cosmo Blatz for prompt respond and help From menu - setup - system ---^ gives the the following :- A/V setting , Customize , User interface , Auto language selection , Network , Language , Timezone , HDMI-CECT setup , Skin , Video fine tuning . There is no Hard Disk where is it ? Can...
  7. A

    Xtrend ET 10000 Quad G-Edition Linux VLan PVR Receiver

    Hi, guys I bought the bove receiver with a built-in HDD 4Tra Bit installed inside it , When I turned the receiver on , and by using the remote controle I went to the main menu---> Information---> service I got in the sub-menu this ( HDD is not Available ) , But when to the main menu--->...
  8. A

    What is the actual paint of satellite dish used by satellite dishes factory ?

    Why would a reflective (lead) paint applied to the reflector would negatively affect the surface from properly reflecting a signal? Not following this idea From previous questions I asked many English and American satellite reception fourms they told me paint should not contain LEAD because...
  9. A

    What is the actual paint of satellite dish used by satellite dishes factory ?

    Thanks again SatelliteAV for help , Can you specify any brand for flat or matte finish paint that does not contain lead to look for in the market
  10. A

    What is the actual paint of satellite dish used by satellite dishes factory ?

    -------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- THANKS satelliteAV for quick reply could you please explain what do you by "...
  11. A

    What is the actual paint of satellite dish used by satellite dishes factory ?

    I have a rusty dish and want to file and polish it in order to re-paint it with the original paint of the dish when it was new - Therefore what is the correct fourmula or contents to make a mixture of paint excactly the same as the satellite dishes factory paint . Please Advice Best Regards...
  12. A

    Which is better Ku-LNB for Prime Focus 360cm sold ( 4 pieces ) dish shown below

    Hi, Guys I have a prime focus 360cm sold (4 pieces ) dish which has a narrow focal point which needs a large Ku-LNB with circular Rings that can collect more signal Rays towards the focal point therefore I have already these two Ku-LNBs shown below which one do you think is better for this large...
  13. A

    Can I connect an external HDD additional to the internal HDD to VU+ Ultimo

    Hi, Guys I purchased a brand new satellite receiver ( VU+ Ultimo ) at the dealer store they installed internally an e-SATA 2Tera HDD and they told me I can not install an external HDD through the e-SATA USB port as far there is HDD installed inside the receiver , But there are two USB ports...
  14. A

    LNB2 IN is not receiving signals from DiSEqC#2 in Humax iCORD HD

    ---------------------------------------------------------------------------------------------------------------------------- As You said This is does not require any opening the receiver , I did meaured the voltage of LNB#2 IN and I found the voltage on the LNB#2 IN is 18 VDC which means
  15. A

    LNB2 IN is not receiving signals from DiSEqC#2 in Humax iCORD HD

    ------------------------------------------------------------------------------------------------------------------------------- Thanks to all trinidex , gabshere and guacharaca for trying to help me to solve my problem I would like to tell you all that all DiSEqC switches are all work...
  16. A

    LNB2 IN is not receiving signals from DiSEqC#2 in Humax iCORD HD

    ---------------------------------------------------------------------------------------------------------------------------- Thanks guacharaca for reply and help Regarding Test # 3 The receiver is a brand new only two months used and it is under gaurantee for two years and it is seald...
  17. A

    LNB2 IN is not receiving signals from DiSEqC#2 in Humax iCORD HD

    ----------------------------------------------------------------------------------------------------------------------------- Thanks trinidex again for help Now you are talking technical that is what I want Before discussing your technical respond , I have tested DiSEqC #2 on other...
  18. A

    LNB2 IN is not receiving signals from DiSEqC#2 in Humax iCORD HD

    --------------------------------------------------------------------------------------------------------------------------- Thanks trinidex for reply and help Your First Test I did not understand could you please elaporate futher what does it meams ??? Your Second Test I did...
  19. A

    LNB2 IN is not receiving signals from DiSEqC#2 in Humax iCORD HD

    Hi , Guys I attached for you a diagram shows my connection to my satellite receiver Humax iCORD HD four satellites connected to DiSEqC#1 which is connecte to LNB1 IN . And four satellites connected to DiSEqC#2 which is connected to LNB2 IN as shown in the diagramme , I programme...
  20. A

    Is Astra 3B at 23.5 Deg East receivable at Riyadh - Saudi Arabia ?

    -------------------------------------------------------------------------------------------------------------------------- Thanks Kallesatman for respond and help I am trying to receive some free channels transmitted on these two frequencies 11914 H 27500 3/4 and 11934 V 27500 3/4from...
Top