Search results for query: *

I was seeing no Broadcast traffic. The Ethernet Switch was not passing any traffic to the PC that I have WireShark on. It was like the Ethernet Switch was too busy to pass any traffic. My laptop that is connected via Wireless to a Router that is upstream from the Ethernet Switch was still...

OK I had another "Network Flood" today. I started Wireshark and it showed no packets at my PC Interface. I could see the lights blinking on my Ethernet Switch between the H21 and the HR21 so whatever is happening doesn't appear to be Broadcast Packets. The problem went away as soon as I...

As mentioned in my reply to your other post, I have seen the exact problem that you describe above. I am using an 8 port Aopen Ethernet switch. I was not using MRV when the problem occurred here.

Thanks for the post srrudin. I am seeing the same problems with my H21-100. Very unstable release. I like your description of the "Network Storm" . It happened to me and I was scratching my head to try to figure out what device caused it. I am also seeing the SWM problems that you describe on...

OK, more testing showed that my Custom Favorite List was the cause of the last problem in my above post. All Channels were Removed from the list.

Downloaded this CE to my H21-100 primarily to test MRV. MRV works but I have had to reboot several times due to the following issues: I've seen the Searching for Satellite issue that is mentioned in the release notes twice. I was able to restart the receiver from the Menu. The picture froze...

The Winegard SK-3005 has a built-in DVB receiver that it uses to Identify the Satellites. This receiver is connected to the ODU before the four user outputs. It needs a standard 950 Mhz to 1450 Mhz input so it would not be compatible with the SWM ODU. The SWM8 would be connected to the four user...

A SWM8 should work. You cannot change to a SWM ODU. The SK-3005 has a build in DVB receiver that uses signals from the standard ODU.

Probably a bad cable or bad connector in the cable for tuner number 2. Swap the tuner 1 and tuner 2 cables. If problem moves to tuner 1 you need to check you cable and connectiors.

The Dish that you have is equivalent to a 5LNB Multi-sat. The newer receivers will auto sense the dish type. Just hook it up and it should figure out the correct setting.

Make sure that the 5LNB ODU on your Slimline dish has 4 connectors on it. If it has only one connector, it is a SWM ODU and it will not work with the Hr10-250. Post Number 4 above gives you the correct information. Use the Elevation and Azimuth and Skew Values that the Hr10-250 Guided Setup...

My experience with both the SWM5 and SWM3 is that if you watch the install Videos on YouTube you can achieve good results in under thirty minutes. Yes there are several steps that you need to follow. It can be done with even a simple signal meter or if you have a helper you can do it with the...

Have Your Tried a SWM Setup I would suggest that your try a SWM8 or SWM S ODU. Another Option would be to install a higher grade Coax.