Search results for query: *

I recently installed an HD DVR hooked into my WB6x8. AFAIK, everything has worked out well the past couple of days. Today someone complained that some channels in the 229 - 235 range weren't working (at a minimum 229 and 230). The error was no signal on tuner 2. There were no recordings in...

The problem was due to a faulty ASL-1.

okay, with the way the manuals and everything say, it made it sound that you couldn't peak it again.

The third way is how I was doing it, which is how you're supposed to do it if your meter doesn't support SWM. I RMA'ed the ASL-1 through Solid Signal and received one that works this time. I'm able to see signals now, but they're significantly lower than the AT-9 I tuned on the other side...

I'm trying to setup a SWM LNB. I have purchased an ASL-1 and am trying to align, but my AcuTrac 3 rental isn't seeing anything (it worked on my AT-9). I noticed that the power inserter's LED was flashing. I tracked it down to being when the ASL-1 is plugged in, it flashes. Ideas? Solid...

My problem was that I was lining up on 110 instead of 101. Now that I have that corrected, I've never seen signal this good! I saw 10x 100s on one of my receivers. I'll be calling DirecTV about the water tomorrow.

I rented an AcuTrac 3 for the installation of some AU-9S dishes. While I had it, I'd figure I'd align my AT-9. Using dithering, I've peaked azimuth and elevation. However, when I adjust the tilt, I'm way out there. I'm supposed to have 75 tilt and the best signal I have is as low as the tilt...