Search results for query: *

I have 4 dishes pointing 97w, 95w, 87w, 83w and connected to 3 receivers, using two 4x4 multiswitch (Zinwell and Digiwave), three 2x1 Diseqc. Two of my receivers having cable length more than 75ft and having signal issues with some satellites. I'm not sure any non-power switches out there can...

Hi all, I have 3 dishes, one point at 97W, one point at 95W and one point at 101W, all joined via multi-switch and connected to three receivers - ViewSat ultra, Captive Works (CW-700S), VisionSAT IV-200. All receivers are able to get signals properly, no issues at all. Here is my current...

It is a little lengthy but try best to describe my current configuration so that someone can provide suggestions on my my puzzle... Receivers: - VisionSat with firmware 1.45 - ViewSat Lite Switch: Zinwell 4x4 Multi-switch (SAM-4402-3A). I see these labels on the switch... 18V 13V...

Now that I have two FTA dishes up and tested working properly with a receiver via 4x1 Diseqc. I'm looking to get a multi-switch for three receivers (Viewsat and 2 Visionsat). Does Zinwell 4x4 multi-switch works with FTA receivers? I found a local dealer that sell them but didn't say it is for...

I have read Iceberg's sticky thread on DiSEqC and little concern with DiSEqC 1.2 requirement to control motor. diseqc 1.0 means it will work with a 2x1 or 4x1 diseqc switch diseqc 1.1 means it will work with a 8x1 switch diseqc 1.2 means it can control a motor diseqc 1.3 means it has USALS...

Fortec Dual Universal Linear LNB 30 Inch Winegard Dish -2X VisionSAT (IV200 PVR) - Viewsat Ultra Lite - No motor My current dish can point to Galaxy 3c or Galaxy 19 easily but one at a time, with good signal above 80%. I want to get one more dish for galaxy 19 and AMC 4. The two dishes will...

Just wondering anyone had bad experience with elevation scale on FTA 33" dish? I had a Winegard 30" dish and the scale is very accurate once the mast is plump. I was trying to help a friend's to aim his 33" dish and was having problem trying to locate Galaxy 3C. I used my Visionsat IV 20 PVR...

I'm a newbie.... I have this dual LNB - FSKU2VN (Fortec Star), Viewsat Ultra Lite receiver. I have no motor and DiSEqC for now. Just straight coax from LNB to my receiver. The dish is mounted about 10' above ground and have some big trees 100' frpm the setup. I'm pointing to Satellite G3C...

Hi all, I'm total newbie to FTA...I'm looking to get a satellite receiver to receive these Chinese channels - CCTV4, MACTV (broadcast on G3C) and NTDTV (broadcast on Telestar 5). Based on some internet information (not confirm) that it seems CCTV4 requires these receivers 'Coship CDVB2000 or...