Search results for query: *

3.88 I think

yes. When it is done, I get all X's. It says no switchbox detected.

Well my problem is, that if I remove my 301 and put the 811 in it's place I get no signal. Signal is fine on the 301. I am positive I'm plugging the satellite feed into the proper input on the back of the receiver. Any ideas?

Can I use an SW21 switch with an 811? I currently have a 301.....

Yeah, you do hit "info" again. Thanks for the tip. Too bad it still didn't solve my problem...

Anybody know how to do this on an 811? I can get to the screen where it says Memory Dump and Device Status. Now what? It shows numbers in the bottom left and Cancel in the bottom right.... Anybody know?

k, I'm positive I have it plugged in the right port. Satellite In. I've done a check switch without the input connected then did it again with the switch connected. Still nothing. Anybody else have any ideas? Also, the check switch takes forever. And yes my other receiver is still getting...

Ok... I read another message about this the other day and it said to disconnect all of my receivers for at least 10 minutes, which I did. Then plug the 811 back in by itself. It actually worked. I got my signal back and ran the check switch and got both satellites. Then I lost my signal 10...

Just got an 811 (not sure why since they're going to be done soon but...) I have 301 receiver as well. When I hook up the 301 I get 119 and 110 with great signal strength. When I hook up the 811 I get nothing. I have single dish with two LNBs side by side (not attached to each other). I have...