Search results for query: *

For a whole month was plagued with seemingly random signal outages on my BUD. Swapped RX, LNB, DiSEqC switches, even the positioner (ASC-1). It started with a drop in SNR after about one hour on the same xponder. Eventually, I couldn't maintain lock for more than ten minutes. The quick fix...

Following up. Ran new Cat6 STP dedicated to servo action 100% from ASC1 to servo. Pairs were doubled for each line (5VDC = WhBu/But, Pulse = WhOr/Or, Gnd = WhGn/Gn) to keep voltage drop in check over this long run. Super clean action now. Thanks Ti and EST for the the on this one.

I hear y'all on ragging me on the wire choice. ;). No prob. Here is some more detail... It is not quite so ugly as 100% cat. Leg 1 is about 15' (ASC1 TO BASEMENT TVSS JUNCT) .as described 1 run Cat6. LEG 2 is abt 225' (HOUSE TO ANT MAST). Here, motor hops off to a larger gauge -- direct...

Here's a fun one. Linkbox 9000iLocal Ti ASC1 250' of cable Uniden 10' w/ VonWiess linear mover Chapparal C/Ku servo-driven feed Worked great up until a few weeks ago. Started losing servos -- or apparently so -- polarity control would disappear. Swapped three of them. Then I took a pull...