Reply to thread

Message

[QUOTE="Mr Tony, post: 2731134, member: 1117"]
I've had this issue for a while but I'll just throw this out in case someone knows a solution

My azbox elite (the original model) with its busted ethernet port has a major glitch when powering up from a power outage/unplugging. If the power goes out (this also means flip the switch on the back), when it comes back on it will sit on "booting" and requires anywhere between one to even 5 switch off and on the back then it finally gets past that stage. I count to 50 and if the booting still shows then its a required reboot. Kinda a pain in the butt if you ask me because sometimes I need to unplug the cable from it to hook up a C-Band setup so I do kinda rule #1 and leave the power on when I swap cables

Its version 5306 or 5307 I've been using. If I do a reboot from the menus it works fine and its not like others have had where the "booting" is permanent on there. This is more of a nag.

So anybody run into it and how do I fix it?

Thanks!
[/QUOTE]

Verification

Search

Search

Reply to thread