Dish 1000.2 Hybrid and a 211k?

Rjgobell

Member
Original poster
May 25, 2019
14
5
USA
Greetings,

I recently graduated up to a Hooper 3 with one Joey. When the Hooper was installed, the installer installed a 1000.2 Dishpro Hybrid triple LNBF using the #1 port in the LNB with the #2 open. I’m wondering if it is possible to install a 211k using the second port in the LNB. I appreciate any insight.
 
Thanks guys. I kinda thought it was going to be a challenge and wanted to avoid putting up a new dish. I’m not sure if the Dish Pro plus is a new one. How would I know?
 
Bobby, would you happen to have a wiring diagram to show how the DPP+ and DPH 42 switch would be wired for my situation?
 
Here you go:
upload_2019-10-23_18-33-10.png
 
I’m grasping at straws here but could you hookup the Hooper to port 2 and use port one for the Wally?

No. The only port a Hopper 3 will work on is port #1. Your only solutions are either a separate dish for the 211K or Wally or a DPH42 and a DPP LNB.
 
  • Like
Reactions: charlesrshell

Watching DVR on Hopper 3 with No Satellite Signal?

Recommended Meter

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Who Read This Thread (Total Members: 7)