There's been some changes in my local station's ownership resulting in broadcast chanel numbers, etc. lineups. The Dish satellite channel broadcast have properly changed to match but my local OTA CW Network, which was moved to a different sub-channel under the same primary, no longer has guide information. How does the OTA module get guide information, is it actually contained in the OTA signal or, provided by the local to Dish in some other manner. I'm trying to figure out who to be asking about getting this restored.
On a side note, I'm seeing another anomaly on this same channel. It's being broadcast in HD but the picture quality is thoroughly screwed up. For one thing, the image is horrible quality, zoomed format and, the format button on the Hopper remote does nothing - zero effect- on this channel. Any other channel, satellite or OTA, it's fine. This channel moved from a .2 subchannel to a .3 with the same tower & ownership. I'm hoping this is a temporary local glitch & plan to contact the station about all the issues - just not sure about the guide content and cannot grasp why or how my format button is disabled on a single channel.
On a side note, I'm seeing another anomaly on this same channel. It's being broadcast in HD but the picture quality is thoroughly screwed up. For one thing, the image is horrible quality, zoomed format and, the format button on the Hopper remote does nothing - zero effect- on this channel. Any other channel, satellite or OTA, it's fine. This channel moved from a .2 subchannel to a .3 with the same tower & ownership. I'm hoping this is a temporary local glitch & plan to contact the station about all the issues - just not sure about the guide content and cannot grasp why or how my format button is disabled on a single channel.