Recent content by B-Dub

Good deal! I will have my additional 622 in a couple of days! Thanks guys!

I have sent it, now I wait and see. :D

When you emailed, what info did you include? Account number etc?

I have 3 HD tv's, and (D!sh) refuses to allow me to have two 622's and a 211. Is there any way around this? I kindly asked the CSR what dish was going to do in the coming future when more people are going to have mulitiple HDTV's? She told me that they will just have to purchase it outright. I...

Can I combine my OTA signal into the cable running my dish's feed, so I do not have to run another cable. I know I have seen a post on this topic before, and I believe it can be done. Any info would be great. Thanks you in advance. B-Dub

I have finally found the problem! For some reason there was something wrong with the coax that was running from the dpp44 to the 622, which is the port number 1 I had the power inserter ran into. After I did the steps above, and found no end to my torment, I got pissed and ran coax half way...

Yup, its good stuff. I get it straight from the factory.

I have swapped out LNB's, and have physically taken a receiver and power inserter out into the garage where the switch is, and hooked up a little 19 inch tv directly to the switch....It works just fine. If I take the receiver and inserter back into the house and hook it into wall outlet dish...

After the switch test, it gives me no signal, and reverts itself to "no device detected" Even though it starts the 50 test, in the end, there is no switch detected. I have the dish marked with a sharpie to show aim location, and the dish has not physically moved.

Hey guys, I am having a bit of trouble with my dish setup. I think I may have the answer to my question, but I would like some feedback. I have a 301, 211, and a 622 attached to a Dish 1000 using a DPP44 switch. The other evening, we experienced a terrible storm with alot of lightning. My main...

Thanks guys. I appreciate your help.

I have one splice, in the junction box where the cable from the switch connects to the cable traveling through the wall. One wall plate at the receiver. I actually had one more splce before I installe the switch. It was located right inside the wall where the cable from the dish ran into the...

Hello, I have a bit of a problem. I have searched for the answer, and have came across a few possible answers. Last week I installed a DP34 switch so I could run multiple receivers. I have a Dish 1000 and a VIP 211. I need the switch so I can feed the 211, a 622 and a 301. I currently only have...