Recent content by cpenni

thanks anole i have been reading some of the post and learned a little about the dish. i wouldn't use it for c band as i have that covered i just try and get as many dishes as i can and there are three on the same block as this one. i hadn't got close yet but one may be a birdview. it's always...

I'm working on a bracket that will bolt to the pole and extend up then hook a block and tackle to pick the disc up off the pole and let it down. I'll post pictures when it's finished just need to weld it together.

what is this could someone tell me what kind of dish this is and if it's worth $50 it is a fixed dish

i just got my DVB-S2 2104 USB BOX and it said it supports USALS but i don't see it any where and the satellite position is not right. Is there a good set up guide for this? thanks for any help.

thanks Lak7 i found a step by step guide on another site. now i just need to fine tune a little.

yes i have 3845 and 4000 WHT-1 . i also have 4119 ionlife on AMC1 but no sound i noticed that the audio pid is not the same as the one listed. i have 4096 TLN-1 on Anik F1. these are the ones i've found so far by luck. thanks

I have been reading post all day. the more i read the more confused i get. i just got a Vbox and trying to set the satellites up. Before i got the Vbox i was set at 99 w G16 i have a viewsat pvr7000 10' unimesh with a DMX741. the dish came from close by so i didn't change the settings. i tried...

how can i know if the unit is good or not?

thanks Tvropro i had just looked on *bay and they had a lot of different kinds but the 920 & 922 just stood out as the best. should i be able to subscribe with a used 922 or do i need to look for something special about the receiver?I'm just getting started with C band. ihave a unimesh 10'...

i see that everybody likes the 922 & 920 and are still high priced. what other old receiver is worth looking for?

i have a digisat meter and installed it in line and watched the voltage i see how it works now. from reading the forums i figured out to set Ku signal i turn the LNB or move it closer or further away. is this correct? i have learned a lot in the last week thanks for all the replys:).

Ok so if i can lock on to V channels it is switching. yes i can see HD and the 4:2:2 channels. Thanks

shouldn't i get a couple of V channels that i could check to make sure everything is working? my goal is to add a actuator an get Ku also. Thanks

no i can't get those well no picture just sound.

Thanks guys i got the locals. does it swap between H and V by its self i see the 22Khz under the LMB menu its set to off.