Recent content by dlf35121

i have the stylus the ipod is my grandsons and my he has my pc. i think ill just check the forum out thanks Anole

I see what you are saying.iwas useing a iPod and I would use the space bar instead of . And I didn't no it would put all the words togeather I no not to use a iPod to answer.

sorry about that when im searching in google i just type it in

when i was useing the HTS-70 i didn't have any trouble but when i went to the vbox -x and change the sensor that when motor would move the dish to much for the ku side of the satellite i check my magnet wheel all magnets are in the same polarity if you placed them 1/4 " a part...

i bought this one in september #59065-01-ND SENSOR MAGNETIC SPST-NO 5/16 THD from them this was the one somebody posted on the forum its not the one that works with the birdview mount i have the part number of the correct sensor they might can match the part thanks for the info

motor 36V i have a motor i'm going to change it out thanks

you right i need the one that came with the kit. they are hard to find the one that went bad has a part # and some numbers thanks

hi Long Gunman im useing a birdview h&h mount with the pod convision to reed. i have the 2" wheel with 8 magnet and i put a reed sensor that worked with a 1" round magnet. ive seen a few modifaction to the birdview mount on the forum. i think these bv h&h mount wouldn't design for ku band...

the vbox moves my dish to far when i try to fine tune. i need to get the right reed sensor i order one from digi-key didn't work then i use one from a actuator

i used this receiver to move my 10ft mesh dish mounted on a birdview h&h mount we had a lighting storm and it hit a tranformer run in on tv/hts70/741u lnbf /reed sensor on h&h mount 2 week later bought a vbox and replaced the reed sensor with one from a actuator now only have 5 or 6...