Recent content by Doorguru

Thanks for the info. I read your thread at LegitFTA and tried your resolution tricks with negative results, but then again, maybe my TV is not compatible. I also had it hooked to a PC monitor and changed the settings using Webif. I assume it didn't matter being connected to both (ethernet and...

I plan on buying a replacement receiver. I decided on the Amiko Mini HD265. It is all I currently need for my single LNB fixed dish and @ $80.00, it's inexpensive . Any reasons not to? Are there better choices?

TNAP 5 in slot one. Played with the video settings in Webif. No change. Still no HDMI video. I am kicking a dead horse.

So, I cleared the slots. Now when I boot up It stays stuck on the EDISION splash screen and I am unable to connect with Webif. Does it sound like I did it correctly? Also no longer shown in my network map..

5R2P Diode array circuit too tiny for me to work on... maybe in my younger days.. chip dimensions 2.5×1.0×0.5mm.. line 40 of these chips up the long way and you would have the length of a cigarette..

I am not sure of the procedure. I will do some searching to try and figure it out. Whatever happened to my STB, happened on it's own. The last time it was used (many moons ago), I had video. It has always been powered up which is why I suspected a HW problem due to lightning storms and power...

Never thought of that, but I did just check it.. probably within specs @ 13.5 Volts.

They ditched the HDMI switch. EB said: "It's good you bypassed the HDMI multi switch. Through a setup please use just a cable from the receiver to the TV." I can easily hook it to my TV set and still change the MIO video settings with Webif. Is that what you mean?

Yes, #15, I have tried that and could not get any HDMI video, regardless of any video settings that I tried.

Check this link out. Exact same problem as mine. A long thread, but in the end, EB suggested it was a hardware issue. https://legitfta.com/forum/showthread.php?27334-OS-MIO-4k-no-signal-after-Edison-screen&language=fr

Flashed TNAP to slot 2. Went through the menu via Webif and

Flashed TNAP to slot 2 and rebooted to slot 2.. still no HDMI video. (screen shot below as seen within Webif. No HDMI signal on monitor)

So put TNAP-5 in both slots 1 and 2 ?

"Have you tried flashing a DIFFERENT slot other than the one it's booting into now with TNAP 4.0 multiboot image, and then booting that up? You can do that all through the Webif screen, though it'll be a little harder." Flashed TNAP-5-osmio4kplus-20230717_usb It shows it is installed in Webif...

Got it thanks! Onward through the fog!