Recent content by dpeople

I got a new receiver and it was working great up until this week so I tried swapping it out with the other box in the living room (that one was working fine) the bed room receiver was doing the same thing in the living room so I put it back in the bed room and it was worked again the only...

Yes they are. And I ran a coax from the bedroom wall jack to the living room tv and no issues. Which I think would rule out the wiring and the swim splitter so I think it would have to be the box at this point.

I think I've eliminated all wiring issues by running a wire directly from the swim splitter to the receiver and then directly from the PI (which works on the other tv) to the receiver and getting the same results. Tonight I will run a coax from the bedroom wall jack to the living room receiver...

These are the number on the seccond (bad) TV.

I added the R its just an H24-700

its not DVR its just a HD receiver. I did eliminate the PI being a problem. I connected the bad receiver directly into the output of the PI and go the same problem.

I have a Swim set up and my main tv works great the other TV in my bedroom will pixelate a lot the TV that works fine is where the PI is connected. I have tried running a brand new wire straight from the swim splitter to the receiver and even tried a different end on the splitter and still get...

Looks like I got some aligning to do on 99c my highest is in the middle 50s. The 103ca is in the 20s and the CB highest is mid 50s too. I just noticed today I'm not getting certain channels which makes sense. I'm guessing these aren't easy to align either.

What should the numbers in the grid be?

should I be looking at the bar or the numbers that come up on the grid? Does it matter which degree etc I'm looking at?

Hooked it all up last night and everything seemed to working fine. The previous people had two more boxes hooked up should I put terminators on those lines that are not in use in the house? Thanks again for all your help.

I thought of that too but I hope not when we toured the place they still had Directv boxes hooked up. Thanks for all your help.

so here was what was in the "service box" from what I have learned from you the red trimmed coax needs to be plugged into a PI then out of the PI into the SAT1 input on the back of the box. I do not need anything else and it should work. Correct?

Yup I ordered one today.

Thanks for your help from looking at it before I'm assuming there must not be a PI connected.