Recent content by dupont2010

im in salem, ny neighbor, and get 25 or so, but between 72, and 61.5 all channels are there. because of hd duplicates, didnt care what 77 says, lol not using it

from install Manuel. Using a peaking meter attached to the DPP 1000.4 LNBF PORT 2, rough peak the dish on 72.7°W using transponder 19 or 21 for maximum strength. Lock the mast clamp bolts (see Table 1) and re-confirm signal (page 5, steps 2 and 3). Note: If using a peaking meter, only odd...

i did, but it was the fiber optics. i ran audio over fiber to surround, and kept going out, finally stopped. not sure if it was just fiber??? but dish sent new 722

you can use an old vcr, run coax into vcr, and rca cable out to tv

when cascading switches, dont not cross wires

i believe for $99 dish will move your system, with out a contract. call and ask, better and far easier if installer moves it. they bring a new dish and all

510, 508 dvr's are junk! sorry, they have been out dated for close to 5 years. the drive is probably going bad, that was there or is there issue's. you can probably upgrade to a 625 for $50-$75???? i dont know, but a 625 dvr will record 2 shows at once or watch 1, record 1. call dish and you...

well what state( different dish and satellites depending where u r located) is it a 1 dish set up or 2 dishes? look in the direction of the dish, is a tree nearby? im assuming your hd sat is 129, that would be the right side of dish. a quick try, is unplug receiver, when it boots up (and u have...

wait until after dish is done fighting with rupert murdoc, over fox channel, and yes thats all fox channels i believe. theres threat dish customers are gonna lose fox

yes, not sure if there is a menu option to format it yourself on dish receiver.

make sure line 1 goes to port 1, and so forth on the 1st,2nd 3rd switch dont cross or mix up wires, or you'll have all sorts of signal issues

you could also, look for that show on a later time, and reset your timer. delete current at say 8pm, and find same program on at 11pm, most shows on cable channel( not locals) repeat constantly! lol

try this, its pretty new NEW Dish Network SlingLink TURBO W1 SL300-100 Ethernet - eBay (item 180568741683 end time Oct-30-10 10:54:13 PDT)

dish network usually monitors lnb drifts, ive gotten service calls, because dish called customer and told customer about the issue. in short, we just replace lnb and its fixed, but yes lnb is failing call dish they will verify, the info on your screen

wow, look on ebay and get holland 2amp diplexers, there blue, if they dont work run the 2nd line shop around you can find them for $2 each