Recent content by fastmobilehome

  1. F

    New to this site, but going to jump right in with a tech question...

    Is that those litte testers that have the lights for polarity or is this a tester for voltage issues??? Thanks, Fast
  2. F

    New to this site, but going to jump right in with a tech question...

    I agree Jimbo, but I do feel this situation has something to do with the ancient electrical service that exsists in this home. The homeowner is having it rewired, because of the service is out of date...only a 60 amp service...The reason I think this is; I had an upgrade, installed the dish and...
  3. F

    New to this site, but going to jump right in with a tech question...

    was a slimline 5, spoke with the tech today and solved the problem disconnecting the hd/ dvr receiver and hooked up the standard before reconnecting the hd/dvr and said it programmed in fine, then hooked up the hd/dvr and both receivers were finally working. This made no sense to me, but if it...
  4. F

    New to this site, but going to jump right in with a tech question...

    By the way it is a KA/KU dish and four lines run to a ground block and then three into the home...again..no clue what may be causing this issue....thanks again so much for your input.....
  5. F

    New to this site, but going to jump right in with a tech question...

    I stopped onsite to see if I could be a possible help...Checked signal with bird dog at both rooms signal strength at both locations was the same (high 90's) that is what confused me as well...no shorting that I could see, there again would you get a high signal strength with a bad LNB, with...
  6. F

    New to this site, but going to jump right in with a tech question...

    He installed receiver in the living room and got the same results, yet when the hd receiver was installed in the set up programmed in properly with no loss of signal strength...our supervisor told him to change the LNB, but taking this into consideration... don't think we would get a high signal...
  7. F

    New to this site, but going to jump right in with a tech question...

    HI all, new to this site, but I am going to jump right in and ask for advise with a problem that a fellow tech has called me on. He has installed numerous standard receivers and they show no signal, but yet checking for signal strength at the receiver end, has been high 90's...yet when receiver...
Top