Recent content by frepp

If you could give us guys with 6ft dishes a good chance of receiving DVB-S2 like Luken 3920 on 87W would pay $100.

Thanks for taking the time for reply. Have located a few 10ft dishes in northern Mn.

Tuner sensitivity to work with 6ft dish/LNB limitations with DVB-S2 signals - if possible?

Thanks for reply! Very cold here in MN and thought may be LNB.

I upgraded my firmware and now when I scan can not get 4000H 7000SR. Is signal still there on that TP?

If you have access to a spectrum analyzer it would be interesting to document the side lobe signal levels of your 6 footer on this frequency. I believe that you will find that their is another carrier present. I do have access to a spectrum analyzer from my previous job. When the weather warms...

Well, was hoping that MicroHd could pull in the Luken signal (with a 6ft dish) off 87w that the Pansat could not. It's a good box; just like others have said there are more limitations with the smaller dish. Would be great if there was someway through firmware to work with less CNR/SNR.

What is inline between the receivers and LNBF? Switches, splitters, etc. Nothing. Have you bypassed a run directly to the LNBFs to verify no auxiliary equipment incompatibilities? Replaced BSC621 with an ESX 241 HDTV Digital Ready 13K 70dB C Band Satellite LNB LNBF With Scalar Ring. This...

Thanks guys - that is why I bought the MicroHD to replace the Pansat. Wonder if I could mail my receiver to you guys to check out? There is for some reason a difference and not in a way we would like.

I am a Senior Principle Tech for a medical device company here in Mn and ALWAYS turn off power when swapping cables. Also, know how to operate the 22kHz to switch between Ku and c-band. I'd also make sure your system was tweaked properly using the MicroHD itself. Perhaps it just needs a tiny...

Sorry guys for another duplicate post - saw that my other thread was being replied to. Does not look like I can delete.

Thanks guys. Was sure hoping for a better receiver. Tomorrow will do a blind scan on both receivers on SES-2 and see if other tp's are weak compared to pansat. Am locked on that 87w for now for my results.

Typo. Did not enter freq manually. Both were blind scanned into tp list.

How would a person know if they have a defective MicroHD when it come to satellite signal capturing? Think I have a bad one.

Tuner Sensitivity Hey MicroHD team. With all things being equal, why would a MicroHd (latest firmware installed) not be able to pick up a satellite signal that a Pansat 9500 can. Like i mentioned, all connections, cable, LNB and 6ft dish are the same for both. They are side by side connected...