Recent content by johnhicks2

Thanks to all, I can breath now. Bringing them up one at a time and just putting in the second dpp44 now. Thanks again, John

Yup, you are correct. Thanks John

Thanks Budda, will try anything at this time. Desperate with a couple thousand out on equipment. Thanks john

Location had 3 receivers working on a 1000.2. Added a new dpp44 to add more receivers and nothing will switch check now. Birddog only sees one sat. Changed the dpp44 and same problem. Moved the power inserter to the switch location and nothing & 21 volts good. What the Heck am I doing...

Me too. Also tried to look at the individual LNBs through the DiSEqC function and couldn't make it work either. I admit I need some training but mostly I need to fine tune 129. Not confident if I am really looking at 119 or 129 when I select them. Will we ever get a Found indication on...

Thanks again for the assistance, Bought a new 44 and replaced the problem one and everything worked as is should. John

You may be right on, I should have run check switch before I left. I knew that. I will go back out later and check things out. Didn't notice the problem myself but the customer did.

Yup, 2 cables from the DPP500 to the input of the 44. losing locals that are on 110 but 119 channels are okay. Also one cable each out with diplexers to the dual recievers and two new drops that are not used yet. Everything worked well before I installed the 44.

Lost one satellite. The configuration before I added a 44 was as follows: DPP500 with two leads going to two dual receivers and back feeding with diplexers. I added a 44 to the system, power inserter at the main receiver, and two more drops to other rooms. No receivers in the new rooms yet. The...