Recent content by jonrho64

  1. J

    No Local Channels?

    No it doesn't but I can get a dishpro dual LNB from a friend...... I have the pics you sent and the instructions, I'll get the dishpro dual LNB or Single LNB from my buddy and do as you instructed. Again thanks so much.... Your help is appreciated and I'll let you know how it goes in a day or...
  2. J

    No Local Channels?

    tHANKS FOR ALL THE INFO AND TIME....... iLL LET YOU KNOW HOW IT GOES! i SEE THE LOGIC IN IT AND IT SHOULD WORK FOR ME... MY LNB SAYS - DUAL LNB - mODEL ZKF-G52N - INPUT FREQ. 12.2 - 12.7 GHz. WILL THIS DO IT?
  3. J

    No Local Channels?

    Ok GOT IT.... i HAVE A DUAL LNB RIGHT HERE. SO I GO FROM THE DUAL LNB TO THE INPUT ON THE TWINDPP AND HOSECLAMP IT JUST AS IN THE PICTURE YOU SENT CORRECT? dOES IT MATTER IF IT IS ON THE LEFT OR RIGHT SIDE OF THE TWINDPP
  4. J

    No Local Channels?

    10-4.. should I just get a new dish and correct LNB for this then or can I just get a new LNB and will I need more than 1 RG6 cable to hook it up?
  5. J

    No Local Channels?

    I have the 250 / no movie channels......
  6. J

    No Local Channels?

    Thanks to both of you Iceberg and Navychop.... Well being the amateur I am I know I have a Twinn DPP LNB with a dish 500 dish. The LNB has 2 connections on the 119 side and one on the 110 side. As for the yoke it fits on the arm with 2 small screws on each side. I have a single RG6 cable...
  7. J

    No Local Channels?

    OK Iceberg, do I need a new LNB or a whole new dish and LNB
  8. J

    No Local Channels?

    I think I did that.... I went to system info, it ran a test and 110, 119 went green and said ok..... 129 was blank unerneath it.
  9. J

    No Local Channels?

    at home my locals are columbus, oh
  10. J

    No Local Channels?

    Bainbridge Ohio..... at home I have 110, 119, amd 129. This is a new receiver and dish at a cabin.... which is still in ohio but about 30 miles from my home
  11. J

    No Local Channels?

    I received great info here earlier today and found I had my dish pointed to the wrong sat. I have that corrected and have good signal (65 to 70) on 119 and (60 to 65) on 110. I have a twin LNB and a 211 receiver. For some reason I get all channels except for the locals. It goes to searching...
  12. J

    Can't lock in Signal on DISH Network

    10-4.... thanks alot, ill give it a try today
  13. J

    Can't lock in Signal on DISH Network

    OK do I go through the list of sats on the dish pointer screen where you put in the transponder, zip code, etc? and will the one i am on say locked or how will i know which one I am on? Thanks
  14. J

    Can't lock in Signal on DISH Network

    Yes, I think it did say wrong sat..... Im not at the cabin now unfortunately