Recent content by kilingiros

OK, Problem was wrong elevation, acquired signal.:) In doing so I broke the elevation adjustment thing:rant: Anyone know where I can get a replacement?:help:

OK, So I ran a new line directly to the receiver, still say searching for sattelite. Once again, I pointed slimline dish to satellites using AcutracIII to aquire signal. One dumb question, switching dishes from 18" round to slimline 5LNB, must one reset reciever configuration to slimline 5LNB...

I'm going to do that this weekend, run a "test" line from the dish directly to the tuner, see what happens......:usa

I too though it migfht be the LNB so I purchase a new one with same results. Sorry, I do not have a model number...............

Yes that is correct, signal at disk (on the roof), no signal at opposite ent of cable (basement). That's usiing the Acutrac III meter, not the recvr meter.

Sorry about the spelling, fat fingers! Replacing the cable is my last option once all others are exhausted since the cable is already wired behind the walls.......Should'nt I still be able to get ku(sd) signal anyway

Replacing the canle is my last option one all otrher are exhausted since the cabel is already wired behind the walls.......Shouldnt I still be able to ket ku(sd) signal anyway?

Four outputs, is there a booster I can put inline?:shocked

Yes its a slimline5. Its about 100 feet (2 X 50) run of RG6. The mast is the new 2" one and its plumb. I get SAT signals at the dish but when I connect the cable to the reciever, there is no signal at the opposit end (receiver end). When I check the signal strenght at about the 50 foot mark...

I'm using Slimline5, cannot pick up any signal using receivers meter

I'm using ACUTRAC III Plus Ka Hi/Lo Ku Satellite Signal Tracking Meter

I'll get the receiver number tonight, but why am I not getting a signal at the point where the cable goe into the reciever?

Hi, I currently have sattelite reception to the box using my 18" round dish. Using RG6 cable that is already wired and working . Switching over to oval 3LNB for HD service. . No signal at receiver. House is wired with RG6 cable. Checked meter reading at garage (thats about half way to receiver)...