Recent content by mccloud147

how is it that when a check switch is completed the installed switch can read as a dpp44 when actually installed is a dp34? 3-311 were installed all new equip. software ver. up to date?

what's the difference between a 211 and 411 ?

that's not funny... my partner actually fell through a few months back... caught himself on a ceiling joist. Bruised him up pretty good... pretty chopped insulation though... falling like pink rain drops... my god it was a mess... it's hell to clean up when the carpet is burbur. lol

Absolutely !!!!!!!!!!!!!!!!!!!

ran all new coax... it's a piece of electronic equipment... mysteries? lol... i've bout pulled all my hair out

as far as pics... i haven't taken any... but since i didn't get the problem resolved, i need to go back tomorrow and figure out something... if i remember i will take pics

went as far as replacing the entire dish... its been with 311's, 322's, 522's so far.

yep

correct

software is up to date... thats something i was thinking about... maybe a software issue

that's also whats weird... if you hook up just the 119 it will read that on the switch... same for the rest... it will find individual sats if you hook them up 1 at a time. I have a bird dog sat meter... reads 100% to 99% on both 119 and 110 meter readings for 105 are at normal for my bd... at...

in the section installed it reads dp feed though... not twin... quad.. just dp feed

yes there is programming but only channels for the 119 signal meter reads nothing for 110 and 105... Thanks for the welcome

I've had 3 or 4 customers having problems... when a check switch is completed on a 105 superdish... with a 34 switch results come back as only ready a dp feed for the 119 only... it's the craziest thing... we've replaced the switch.. same results.. replaced the receiver... same results...