Recent content by mebgardener

You are absolutely right. It's all done. He's sending some folks out to the house tomorrow. Impressive!

Thanks Speedy...just noticed that you are Dish Network Customer Service.

Thanks Speedy. I'll give Dishnetwork a call.

I have the same problem. What is the solution?

I have the same TV and I haven't found a code that works either. I noticed that there is a new learning remote from Dish Network. Maybe you can try to get one.

Again, thank you all! I have 2 analog TVs using the modulated signal from the 622 and the picture quality is impressive. This message is to confirm that RG59 works without adding extra filters/amps and such. Very nice box from E*. On further note, I was not that pleased with the 811 and now I am...

Audio dropouts for me too. Fortunately, it can be remedied by flipping channel up and back down. I also noticed the "All HD" favorite list. I don't think it was there before but it is a nice addition.

Does Rave ever follow their schedule? This is the third time I've tried to auto record The Cure Trilogy and some other programming is on. What gives? Or is this normal for the Rave channel to never follow their schedule?

Thank you all. I will experiment first since the cabling is already there. The only thing I was worried about was that the RG59 wouldn't work. I already knew that the E* requires RG6 for the satellite signal because that was mentioned in the installation guide. However, the guide does not...

My house is pre-wired with RG59 coaxial cables to 4 rooms. I am about to use the modulated output of the 622 to send programming through the existing cabling within my house. My question is, should I bite the bullet and replace the RG59 with RG6? Or Does it matter?

DANG! Why would I subscribe to HD locals if I get it with the OTA?

Nope...I didn't subscribe to locals when I had the 811 either.

The channel guide for every OTA channel has "Digital Service" printed on the new 622. I've tried rescanning and rebooting but I cannot seem to get any listings for the OTA channels. Before upgrading to the 622, the 811 channel guide had listings for the OTA channels. Is there some setting that I...

Thanks for everyone's input. The problem is resolved. I reset the unit 3 times without any success. The fourth time, I decided to unplug the VIP622 for a "hard" reset and that seems to work. Weirdest bug I have ever encountered because originally, the Caller ID history had all the test calls...

Caller ID was working fine with the 811 so I don't think the issue is with call forwarding. I also have a DSL filter attached. Again, I can see in the Call ID history on the VIP622 that calls are recorded. The only issue is that there is no pop up window on the TV screen when a call comes in.