Recent content by Oldster

Has anyone had an issue addressing the counters. My box does not allow me to go over to select any counters?

Thanks for the suggestions. Might have to go with a DB since I'm thinking now of going in the attic and the DB will fit through the hole.

Was also looking at the Winegard Square Shooter SS-2000, anyone have any experience with that unit?

Interesting bit of info I stumbled upon. Looks like I don't even need to move the port 1 off the 622. From Holland: "Allows the combining (or separating if used in the reverse ) of Off-Air / CATV signals with satellite signals to a common cable. Separates TV and satellite signals prior to...

Thanks for all your help. Just ebay'd the diplexers.

Ok, port 1 could be done easily. Now the second part, I will need two diplexers, one at the receiver where I will be splitting to the antenna input and the separater for the dual tuner. Now back at switch for the second diplexer, the sat in one side off the switch and the ota antenna directly...

I do have a second cable off the switch going to a bedroom. My only goal is to get the OTA locals down to the 622. I really don't know how the diplexer works except it would be wonderful if I could do it all on the dish side of the switch. Thanks

I guess I'm kind of dense because I didn't get much out of the drawing. Right now I have one line coming off the DPP44 to the 622 using a seperater at the receiver. The switch is in the attic and accessible but not for power. I would like to continue to have one line coming down to the...

I am using single mode.

Hi, I have a Dish 1000.2 going through a DPP44 to my 622. How can I hook up the Terk to my system? Can it be done without running any more cables. Thanks for the help.

Neat idea, how and where do you hook into you existing Dish wiring system. Thanks

All my recordings were hosed on Sunday. Law and Order recorded for three hours and finally had to hard reboot to get it to stop......

My OTA will not go on the favorites either??

Hmmmm, maybe I should try mine and see what the difference is, good luck with your set up.

Just out of curiosity but why are you running the S video cable to the monitor at all? Why not run the SD and HD through the component output to the monitor and the S video to your switch only? Perhaps I'm just not understanding your setup.