Recent content by scubasteve

yes, just make sure you have dp lnb and not a Dpp lnb on the 500 dish

are any Vinyl Siding Cable Clips on the DN approved parts list ?

a single Dish network box can feed both TV's HD signals. They will be mirrored images so what ever is on TV 1 will be on TV 2. Most Techs will not connect this up for you this way. There are several options for connecting TV 2 for HD, either a HDMI splitter or matrix will work allowing for HDMI...

I thought there was only one six dollar DVR fee per account, and that it covered all DVR's, but you pay three dollars more for lease fee's per month per DVR unit . 211(K) seven per month lease 612 ten per month lease 222(K) fourteen per month lease 722(K) seventeen per month lease Am I...

I have done this, it will work just fine for a limited amount of time, then it seems to "burn out" the diplexers. I would start to see it first on the Sat side with short drops of signal, then the internet speeds started to slow. With in 4 months I ran a second line to the room. Now with Sat and...

Dish does not offer a watch anywhere in the house DVR, The 612 can be seen only on connected tv. The 722 is the same. I am unsure if an EHD would allow for the "transport" of recordings from one 612 to a 722, Someone I am sure will fill in that part.

I was out on a T.C. the other day, issue being customer just did a dish mover from Tenn. area to Central Florida, now on both of customers receivers the Local channels from both areas show up in the guide. (722 and a 211 non k). I have verified with Dish that only the Central Florida locals are...

I have a 211k with the issue now at 600 am every day rebooting and taking for ever to get guide info, I deleted the OTA channels with low signals only to see if that will help, if not I will delete them all and check. But this was not an issue until I connected the ota.

it also allows E* to sell "general" viewing information to google to help them stay out of the red, while they increase the package pricing and equipment charges to the customers, it will also send signal strength reading from the dish to DN so they can monitor if any problems may be going on.

Thought I had read I could use a 1k4 dish with port 2 of a 1k2 hooked to the input port of the 1k4 to get the 61.5/72/77/110 sats, but when I run my check switch it fails to show the 110 on one Rx it shows a 1k2 for port 4 but only says conn, on the other two rx's it just shows port 4 as nc...

they charge the same if you own or lease the equipment so it will not change the billing at all

why not set up a service call for an uninstall, only 15 dollars if you have the Service Plan

The system info "software" does not have the 1K4, it is unaware the eastern arc is there, that is why it still thinks you have the 1k2.

nope, only the 922 is web enabled in that way

First make sure that TV1 is set to be modulated out, (menu-6-1-5), if it is already, try another channel #, then auto scan on the tv you are trying to connect. You should get TV1 and TV2 in both locations. Choose the channel for the TV tuner you wish to view and enjoy. That is if every thing is...