Recent content by southtx

Thanks, I tried again today but no luck. I attempted to get 63w I connected KU Lnb directly to Stb but nothing. I will try to get a DBS and attempt 61.5w. I just don't what the problem could be.

Thanks Ice but I don't have a DBS Lnb but I have a standard Ku Lnb. I was going to attach and try for 63w later today due to it being about 100 degrees outside right now.

My settings are correct. I have Lnb connected to Diseqc switch port to stb.

I live right on the border but for the past 4 days I have been trying to get 58w but no luck. I am using a ULN1 Lnb like I mentioned but nothing I tried different transponders(11612,11960,11980) I moved setup two times to get clear line of sight but still no quality only 90 strength. I skewed...

I am using a universal Lnb (uln1).

Thanks Ice,I will try that; I had tried measuring 0 to -30 then -30 to -60 and set about -51 but got no quality just 76 strength. Maybe, that my not be possible but I will try it alittle past -30.

I am trying to get 58w on a stationary 36" dish with uln1 Lnb. the dish setting ask for a -51 skew but Lnb shows marking to -30 only. How do I get to -51.

Connect it to a diseqc port by itself right.

I have a universal because I am trying to locate mexican satellites and some require universal Lnbs.

Thanks again, will the universal lnb be connected on the off or the on side of the switch and in the Stb setup can I use port 4-sw22 on/ port 4-sw22 off to separate lnbs. I know the photo shows it on port 1.

Thanks Iceberg, so I will need Ecoda 22 Khz. switch.

"I want to win" I want to finally remove my two dish, three Lnb setup. I want to get my wife of my back for be on the roof on and off for a week trying to get a signal.

I want to use the same setup as gmd63 but can a sw21 be used instead of ecoda 22khz.

Sorry, receiver =diseqc switch=port 1 & port 2 connect two DBS Lnbs=port 3 connect to DBS Lnb=port 4 to motor w/KUL1 Lnb. I want to add ULN1 Lnb to motor. Can I use a sw-21 or sw-22 to connect Kul1 & UNL1 then to motor then back to port 4. I live in South Texas and I attempting to get Mexican...

anole, this my set-up