Recent content by tdiwrench

Just to clarify for future readers - I used compression fittings that had rubber O-rings to seal against the insulation (outer) of the RG6 and also on the inside to seal against the actual connection block of the LNB and also SW21. In my case the center conductor on both sides for both cables...

Have had a 722K for a couple of years. Has been flawless up until recently. One of the LNB's took on water. Cleared the water out - sealed it up and all was good for about 7 months Shortly there after (few months) lost signal again. No water was apparent in the LNB - removed the Diplexer and...

so I am 99% sure the 722 came with the splitter thing (too lazy to get out of bed and go look) and it looks like I can get the new lnb off of ebay for about $20 thanks

Thanks - is this one I presume it is one line for 110 and 119 and then if connect to a diplexor to go into the house and another to connect to the receiver to get the two inputs at the receiver

Thanks - would rather not. Could you explain what you meant by the one line comment

Note sure I understand what you are saying - Dish wanted $195 to come out ($100 for the 1000.4 and $95 installation)

The Dish 500 I have has two seperate LNB's mounted on one yoke - both LNB's have two outputs each The receiver it is replacing is a DP510 - 722K was new in box so I have everything that comes in the box. Edit - quick google image search - looks like these

Hi - first post Bought a 722K receiver and wanted to replace my current DVR - went to activate it and was told by Dish that I would need to upgrade my Dish500 antenna to a 1000.4 which they would be happy to do for $195 I bought the receiver mainly for the ability to watch live and record...