Recent content by tony-mt

Hooked the switch up today with two lines from the LNB and everything seems to be working fine. Check Switch showed that there was a problem, but I think that was from not recognizing a third satellite off of the DPP33. Now I have an extra line off of the LNB if I want to put another receiver...

Your help is greatly appreciated, Randall. Thanks again. Can't wait to get that switch so I can get that Dual DVR working for us!

Okay, one more question. I have not received my DPP 33 switch or instructions yet, and have not seen this an any internet research: Does it matter which Satellite In port that the DP QUAD 119 and 110 signals go in to on the DPP 33? I do understand that Ports 1 and 3 on the DP QUAD are for the...

Awesome, this place is great, thanks again, Randall. Dish Network technical assistance had no idea what I was talking about!

Thank you very much, Randall! Do you think the switch should solve my one-line 625 problem and allow me to use the Separator?

Well, considering how the switch is designed to distribute three satellite signals, but I am only using two, Can I just connect two signal lines from the DP QUAD to the switch, and then run the three receiver lines I need from the switch? Will it hurt anything to connect all three 110-119 lines...

Thanks, Randall. It won't be a problem to just place the DPP 33 near the Dish, where there is a four-port coaxial connector already. Will the Solo receivers have trouble recognizing the switch? I understand that there is a software upgrade needed for the Solos to run off the DPP33. I will...

625 receiver is not working with DPP Separator on one line, presumably because I am running the signal line from a DP QUAD LNBF. I do have an open LNBF port on my dish, but do not want to run another line to the receiver. My question is, will installing a DPP 33 switch with the DP QUAD...