Search results for query: *

I have just installed local DSL at my house and no longer need my .98m Dish with a HN7000S modem (1-watt radio on SatMex 5, 117W). The entire system is only 6 mos. old. Looking for owner transfer or outright sale. The system is currently located in the Playa del Carmen area of Mexico. Asking...

Woohoo...Finalmente.... That was the issue! I ran DSSaTool and put in my Lat/Long coords to the modem, then finally, I was able to get into the queue for ACP testing. Was able to PASS ACP within a couple of tries with different transponders and went right thru registration! Thanks...

hi Tate...do you think it would be safe to apply the following commands to store the lat/long into the modem as follows: From a command prompt, type "telnet 192.168.0.1 1953" without the quotes. At the telnet prompt, enter the following keystrokes, where [enter] means hit your return or enter...

Thanks for responding Tate, much appreciated! I am using the original install standard R6 Coax about 100ft in length. I really think this issue could be caused by the Lat / Long parms not being precise enough. Would it be better to enter the Lat/Long parms directly into the modem with...

So...is everyone all out of ideas already?? I'm getting conflicting responses about the importance of the Lat/Long (ZIP Code) parameter for xpol...some say it's NOT checked...others say it is very important? Do I have to notify the NOC that I changed antennas and location? I was originally...

I have an HN7000S modem. I have already RF'd the modem and checked all connections. I have also tried to Force Range the modem, no go. The ZIP code is not applicable, as I have re-pointed it in Mexico (near Cancun), it was originally in Florida. (I have manually enterted the Long/Lat parms). I...

hi, I recently installed a .98c antenna with a horizontal shim. I'm connected to the SatMex5 bird using 1170 transponder (990 works even better). I have over 80% signal strength on receive, however, I cannot get the XPOL to start. Always shows me: "Requesting reply, please wait..." (Both in...