Search results for query: *

Thanks for the info. I know I'll have to cut into the ceiling, but it isn't happening often so it'll have to wait for cold weather when I can't work in the yard. On the two receivers issue, When I use the downstairs setup, I have the DSR 922 slaved to the open box so both are on. I used the...

I decided that the sketch was more important than my trees. I have been in my place for over twenty years, but didn't have the time to landscape. I am retired now so I can get to it. I am not an electrical engineer, I do have a degree in manufacturing engineering, but never woked in that...

What do you mean by bricked? There is an X4 tile, it was there when I first fired it up. On another subject, when I fired it up, I was receiving showtime, showcase, flix and others. after I shut it off and turned it on again, those channels said not authorized. When I look at what the...

well, I'm a little busy, I am planting trees and bushes (125 trees and 150 bushes so far) but I might do a sketch in my spare time. I don't think I have any electrical drawing programs, but I'll see what I can do. Inomad

I am new to the 4DTV world, but I have been reading about it and I have some questions. I seem to have read somewhere that if you park the dish on a canadian satelite, it will download info to the DSR 922 and screw it up. I mainly use the 922 to position the dish so that I can use an FTA...

My next report on the 1 BUD 2 locations problem. I have connected 3 relays to my system. 1 relay for the polarizer sensor, 1 for the motor power and one for the actuator sensor. I used the relays to interupt the positive signal to the sensors and I don't think it matters for the motor power...

I have connected a relay to the polarizers of both boxes. The DRS 922 connection is normally closed and the upstairs box is normally open. I have a power strip with the Pansat, G-box positioner and GI analog box for polarization conected to it along with an old 12 volt power supply from an...

Thanks much, I have had a feeing i would have to cut into the ceiling to replace the splitters. Right now I can watch upstairs or down but I have to move the dish and change the polarity upstairs. (big pain) However, I am noticing that sometimes I don't get a signal upstairs. When That...

Thanks, I haven't connected the control wires to the DSR yet. I have been afraid that if power were on the lines from each box, I might have a problem. Inomad

I have 10 foot dish with C and KU LNBs and a linear actuator. There is a ribbon cable running into the house with 2 coaxes and wires to control the motor and polarizer. I have T'eed the cables and wires to run to a second location. Unfortunately, I used common splitters instead of high...