Search results for query: *

I would replace the 8 way with a 2 way, smaller and fewer splitters the better. Your tuners are going to be dependent on what receivers you eventually get and not the splitters, swapping out the lnb may be easier and quicker if it's even necessary. 1 power inserter is enough but try to keep it...

I see a power cord and a hdmi cable plugged into the back of your receiver but no coax. should have a coax line going from the receiver to the "TO IRD" port on the power inserter and then a coax line going from the "TO SWM" to the LNB. You do not need the green splitter with just one box unless...

Sent ya a message. I'd like to keep some anonymity on forums just in case big brother is watching lol :hiding

Noticed that it's listed in upfront now for ordering but can't select a quantity yet. We're doing repairs but only for the jobs we've installed.

Thanks! That much I pretty much knew but thanks for clarifying just in case anyone else stumbles across this.

Can a PI-29 work fine with a swm LNB without using a swm8 or swm16 in the setup? Obviously the PI-21 would be the preferred choice but if they're not available (out of stock in garage) would a PI-29 be a suitable replacement?

It happens unfortunately. The biggest problem we have is on heavy days between 4-5pm guys will sit on their current job or just not dispatch until the load clear message comes out hoping someone else will pick up the last few jobs.

You know it's bad when you got more drive time than on the job time.

Also depends on location, where dish found good line of sight to the satellite might not be good for dtv. If you got open skies no trees or your house blocking the south east sky (assuming you live in Yakima WA as your profile indicates) then you should be good to go.

I had this happen after my install, waited 2 days and still no OD. I just unplugged the 54 and my router, maybe did a red button reset and got it working.

They will work with alarms, haven't had any issues so far. Just needs to be wired up the same as Pots would. Voip doesn't work very well with credit card PoS systems though, but usually they have it wired up via ethernet if they got voip

ATT is pushing hard to phase out residential and small business pots. Took me nearly 4 hours and at least 6 phone calls just to convert a customer back from voip. They will still keep pots around for a while for emergency services and business using more pots lines than uverse can support. On...

I think what he was getting at was ATT was wanting to phase out any landlines that was not being currently used for uverse. I have no idea what their intentions are. Voip dial tone is post gateway. There is really no difference between internet and voip before it gets to the gateway, its all...

They probably wont shut them down for the reason you just mentioned. They will keep it as a back up. Usually the customer is getting internet anyways and as long as the signal is from the VRAD then there isn't a whole lot more work to do after the Gateway is up to provide the video service since...

ATT is strongly pushing customers over to DTV even to the point that they practically dont offer it anymore through normal sales channels. You have to ask for it otherwise they are going to give you DTV. If a tech come out to do a DTV install but cant install for whatever reason they can switch...

Hey guys got a question. After installing the new reflector, lnb, etc. Assuming I have a clear LoS, level mount, and the dish is properly dithered. The tech said he was getting -27db on meter and followed through the steps. Is it possible to still get failing EIV results particularly on the 99...

I would recommend cat6 or cat5e home runs to each room in conjunction with the coax. no need to run phone lines with it. You really only need two pairs to transmit data leaving 2 pairs available but if you can afford it then i'd run 2 lines to each room. VoIP and Pots will work just fine on...

I haven't heard anything about changing the commitment on our end however they typically don't tell us anything new until after it's implemented. :what

Thanks i'm from Port Clinton. Uverse tech but have been through the training for Dtv and done a few installs. Just trying to figure out whats to expect in the next few months to come

Someone had asked earlier if at&t had any plans of changing the names. They did make some modifications to the logo, both uverse and dtv will have the same globe with their respective names following. This was released within the past week.