Search results for query: *

  1. I

    Multi-Dish install

    boba and SimpleSimon, Thank You for your patience. Finally pinpointed the problem After following boba's last post Turns out the one LNB was bad. Thank You again, couldn't have figured it out without your help.
  2. I

    Multi-Dish install

    SimpleSimon This is exactly what I did, I took the SW21 out of the system,Pulled the Power Plug on IRD Disconnected the Sat. feed behind IRD Powered the IRD up again Hooked directly to the 119 bird (102 sat. sig.) Ran a Check Switch (all threee versions) Nothing was found, so I connected just...
  3. I

    Multi-Dish install

    Finally got both Sat's. locked in Very good signal strength, But after a Switch Test (I am testing a 500 but had to run Super Dish Full to get a read got nothing on Super Dish 3 or Super Dish 4) I am getting No. 1 Xed on the ODD(119). But have 119 EVEN and 110 ODD and EVEN After another Switch...
  4. I

    Multi-Dish install

    Again,Thank You for the many responces. I have tried to switch the LNB's from 110 side to 119 side on the sw21. When I do this,I get no signal at all and after a switch check I get "No switch Detected" but if I put them back to the original setting (119 at 1 and 110 at 2) and do a switch check...
  5. I

    Multi-Dish install

    SimpleSimon Not sure will have to check, will be back after work. Thanks for the Many responces. This is what I am doing, and still no 110. I go to MENU (on Remote) SYSTEM SETUP INSTALLATION, DISH-POINT SIGNAL, then to DISH POINT and SIGNAL STRENGTH PEAK ANGLES. All this does is take me to...
  6. I

    Multi-Dish install

    I have a 3700 IRD (2800 is the same thing isn't it? Have the same problem with it as well) Legacy LNB's sw 21 switch connected and have done numerous switch tests. The 119 is recognized on the Odd and Even but never the 110. Can't be the LNB because I have switched them and the signal comes in...
  7. I

    Multi-Dish install

    I have been having a problem getting the 110 Sat. for quite a while, but after reading, I have found I may have a problem with the IRD. It does not take me to a specific menu. Here is the exact problem, after going to MENU on the Remote control, then selecting SYSTEM SETUP, and then...