Reply to thread

Message: [QUOTE="jrhut1, post: 4121908, member: 173981"] I have had the same issue on my Hopper 3. I unplugged the receiver for 1 minute then plugged it back in. No change. I then ran a check switch test as suggested above. No change. I then performed another reset of the receiver and it still does give me the guide data that it is supposed to. The only thing I saw odd during the resets was that the screen came up for a moment about no signal and to check for obstructions. This was followed by the normal downloading of the guide but instead of 5 minutes or so it took much less than a minute. It was the same after both resets. I am getting very frustrated with the whole thing. Especially with all the new shows about to start. I am also on the eastern arc. [/QUOTE]

Top