Reply to thread

Message: [QUOTE="Mike500, post: 29319, member: 20"] Sounds like the high voltage lnb port to the multiswitch is bad, or the cable connecors or cable connection is bad. The receiver is sending a high voltage signal to the multi-switch to access that part of the dual lnb dedicated to 15-18 volts. You get no signal. Placing a splitter in the line, blocks the 15-18 volt switching signal. The switch defaults to the 11-14 volt side of the dual lnb. You don't say if you are getting only odd or even transponders, but for the information that you have given, this is the most plausable information. [/QUOTE]

Top