Change Ad Consent
Do not sell my data
Forums
Search forums
What's new
Unread posts
Latest posts
Members
Current visitors
Forums
Log in
Register
Search
Search engine:
XenForo Search
Threadloom Search
Search only containers
Search titles only
By:
Search engine:
XenForo Search
Threadloom Search
Search only containers
Search titles only
By:
Search forums
Search
Search engine:
XenForo Search
Threadloom Search
Search only containers
Search titles only
By:
Search engine:
XenForo Search
Threadloom Search
Search only containers
Search titles only
By:
Menu
Install the app
Install
Reply to thread
Forums
Satellite Signals
DISH Network Support Forum
Questions with LNB and Multiswitch
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
[QUOTE="hth, post: 543463, member: 43635"] I have some questions regarding the LNB and multiswitch. Current setup: a Direct TV dish with dual LNBs, 110 and 119. Each LNB has 2 outputs. From the dish, 2 cables (one attached to each LNB) go to a Pansat DiSeqc switch and to a Perfect Vision 3x4 multiswitch. The reason I asked is I never have a good quality signal. I stay on the roof with a 9 in. portable TV for an hour but the quality is just around 60%. I even lost signals of some channels sometimes then next day or day after it comes back normal again. If I do a blind scan on my Pansat 2700 receiver it sometime gets most of the channels back right away. I replaced the Pansat DiSeqc switch with another one, still got same problem. I removed and by-passed the multiswitch, still got same problem. Questions: what is the difference b/w 2 output ports on each LNB? Can I use either one or I must use the one on left or right? If they are the same I can use one port and connect another receiver to the other port on the LNB?. On the 3x4 multiswitch there are a 13V and a 18V port. What port should I use for my current setup? I tried both ports, getting same poor quality result. Only one thing noticed is when I use the 13V port the switch seems to be warm, more than a normal warm. Is it normal for the 3x4 switch to get warm? Thanks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Satellite Signals
DISH Network Support Forum
Questions with LNB and Multiswitch
Top