Recent content by Tribbs

This is also occuring on the Hopper 3? Mine is a HWS.

I have the exact same symptom. Without reading this entire thread what is the solution?

For someone incapable of tweeking my own dish, will DISH come out to tweek it for me?

Which router do you have?

Just an FYI - All my premise distribution coax is Belden 1694A terminated with Canare FP-C connectors - ALL coax, plugs and jacks are 3GHz sweep tested. Ethernet is Belden 1872A CAT6e Mediatwist terminated with Panduit CJ699TP jacks - WiFi? What's that?:nana2 Everything (16 x dual coax & dual...

Not claiming to know much but, would marginal/poor MoCA levels point to a Node or splitter problem? In my case the MoCA levels for both Joeys were full scale green. Your resume is impressive. I'm contemplating retiring from my current position. But as you know, I would very likely walk into...

I hear you! Not to mention the software download time, etc. I was tempted to suggest the node. But, experience has taught me to stay out of the way of experience :bow

No, didn't go near the node. Immediately swapped out the HwS - problem solved. The 118 satellite signal was Yellow so also peaked the dish - Good. Relatively quick and pleasant experience - I give straight "10's" :thumbup

(Bridging enabled) Both Ethernet and MoCA: DHCP Acquired: OK Server Connection: OK Internet Connection: OK Noticed again this morning on the HwS TV, the Channel Guide takes about a minute to bring up. Sometimes the Channel Guide freezes. Tech is here, tried to run some HwS tests on screen...

Spoke with tech support (Performed power cord reset of HwS & Joeys - no change.), said "no known H/J issues" with my symptoms, "suspect cable issue". Scheduled a tech visit for tomorrow morning. Will update, stay tuned...

Disabled bridging, power reset HwS, verified bridging disabled - no difference. Noticed that trying to bring up the Channel Guide on the TV connected to the HwS is very slow. The first time I tried to bring it up this morning I received a Nag to power reset and to call DISH if it doesn't fix...

Madison, WI

Hmmm, I'm watching live satellite programing on the TV at my HwS with no freezing. However, I'm experiencing an intermittent sluggish remote control (new batteries) command response from the HwS.

Yes! Always has been enabled.

UPDATE: I tried watching a program that had just been recorded on the DVR this evening. The freezing can be observed when watching this latest DVR recording on the TV at the HwS or Joeys.