MOSFET'S CORNER*
- Thread starter MosFET77
- Start date
- Latest activity Latest activity:
- Replies 97
- Views 9K
- Status
I WILL BE TAKING NEW PICTURES OF MY NEW POLES AND INSTALL HERE IN ABOUT 2 WEEKS. NEED TO ORDER FAST CEMENT AND GET THE NEIGHBORS POST DIGGER! 
Tester pic link is broken now ....
MY NEW TESTER CAME TODAY! I WILL NO LONGER BE DOING ANY TESTING WHEN IT RAINS! LOL
Sent from my SM-G930V using the SatelliteGuys app!
I just bought some 75 Ohm F-Type Terminator for Cable/Satellite to put on the open ports I have on my disq.
Be very careful using 75 ohm terminators on switches and open ports. Most FTA gear is designed for unterminated open ports. I only use caps without a resistance load. 75 terminators can mess with 22KHz/DiSEqC commands.
Ok I tried the 75ohm terminator and Titanium was right! The terminators terminated my Ses 3 sat. I took them and it works fine now!
If you want to use the terminators as caps to just cover the open ports, just rip/cut out the wire in the center of the terminator.
Leave the bag open and the opening facing down to drain. A sealed bag will collect condensation and cause more problems than having no cover at all.
Cut off cable ends work good to cover unused ports on switches. I push the wire back so that it will not make contact and cut it off from the back side. Works good and is cheap.
I did this exactly! using a freezer bag with one of those plastic blue and it works great!
heheI have the open part of the bag facing down!
- Status
