Campground hook up

[Chris04626]

I have a dish 1000.4 connected to a solo node than cable from node to host hopper and cable to client Joey. My neighbor here can't get signal too many trees in his way. He wants to run a cable from my set up to his camper. Is this possible anyhow he has a regular receiver not a hopper

how would I go about it?

 

[garys]

You should be able to run a third line from the dish (I believe it should have 3 outputs) to the camper as you cannot run it off the node. If you don't have a third output at the dish, you can connect a DPP33 or a DPP44 switch at the dish and connect everything from the switch.

 

[NYDutch]

My 1k4 dish is currently shared by a Hopper/Joey and a VIP211k. Ports 1 and 2 on the LNBF go to the Solo Node, and port 3 goes to the 211k.

 

[garys]

You would need to add a DPP44 switch to add the camper.

 

[NYDutch]

The LNBF on my 1K4 has DPP built in.

 

[sca]

no switch, just run a cable to his receiver. from the lnb. done.

 

[garys]

The OP is already using 3 outputs, he needs a fourth.

 

[osumike]

He shouldn't be using all three outputs.. The solo node only needs two running to it off the lnb. Port 3 should be open..

Posted Via The FREE SatelliteGuys Reader App!

 

[garys]

Reread post #3, he also has a 211k.

 

[agentc13]

Reread post #3, he also has a 211k.

Post #3 isn't by the OP. Two different people posting.

 

[garys]

You're right, can't believe I thought that it was the OP.

 

[NYDutch]

You're right, can't believe I thought that it was the OP.

I posted my current setup just to show the OP that it can be done with his Hopper/Solo Node setup. Port 3 is still available to serve another non-Hopper receiver.