The receiver will freeze up then reset itself about every 20 min. I downloaded new software and it didnt change anything. When it freezes it will not respond to any buttons, power included. Is there anything I can do?
We have the standard HD receiver and the HDMI output works fine on HD channels but if we switch to a standard channel I donot have picture or audio, black screen. Is this normal?
Directv called me, shocking, and said I needed a 200-2150 splitter. Went to best buy and they had a 4-2150 diplexer.....yup that doesnt work either
THANKS AGAIN DIRECTV:mad:
does this sound like what you had?
all connected physically, i check my router and it shows up but it says not connected? did you have that for a few days?
ill have to get into my attic and look but i think i reember only 2 lines coming from my dish....i think my initial install was half assed my local contractor, mastek is aweful
if the directv unhelp guy was right and the problem lies within my router setting what can i check or change? i dont have a firewall enabled
what should my host device IP be?