Recent content by corvette Lew

I did have the unit setup as a slave (if I understand you right). I think I was doing the blind scan per the instructions, if I understand you right. There was an automatic scan that found the transponders, then a manual channel search that tried to find channels. Since I am new to this, what do...

Thanks guys for your support. I did finally get a reply from the company and after some discussion it was decided to return the unit for repair or replacement. Koodoos to your gold sponsor. I assumed that the unit would work out of the box also, but alas it did not. I had lots of questions on...

My new Viewsat2000 has been installed with programming installed from my computer. I still have the same problem, good satellite & transponder signals but no channels to view or listen to. I have submitted a service ticket to the company I purchased it from, ( a gold sponsored company) but am...

Thanks for the reply. Through a previous forum discussion, I used the diagram that I was directed to. On the splitters for both C & Ku bands, the power pass cables go to the 4dtv. The other cables go to the DiSEqC switch, which in turn goes to the Viewsat2000. I verified this connection through...

:cool: I finished integrating a Viewsat2000 with my 4DTV connected to a bud. Upon locating a satellite to view (Galaxy 10R), I did the auto and manual channel search. I get a strong signal from the sat and the transponders but do not get any channels to view or radio to listen to. Also, I have...

Been there, done that. However, on the splitters, which reciever should the power pass cables go to? Currently, I put the power pass to the 4dtv. This gets me the signal from the sat and I can get some transponders, but no channels. I recieved a CD to put on my computer to upload info to the...

Thanks for the reply. I have had the 4dtv for a few years, however my subsriptions have just recently expired. I got into the fta equipment due to the NASA switchover and am trying to get it back. What is IPG? who do I call? (service provider, 4dtv equipment supplier, viewsat supplier, or...

I finished integrating a Viewsat2000 with my 4DTV connected to a bud. Upon locating a satellite to view (Galaxy 10R), I did the auto and manual channel search. I get a signal from the sat and the transponders but do not get any channels to view or radio to listen to. Instruction manual is of no...