Recent content by donsig

  1. D

    Need Help troubleshooting Pro 500 lnb

    Thanks a lot for all your help. Now trying to decide to upgrade to a 722 or buy a rebuilt 522 or 625.
  2. D

    Need Help troubleshooting Pro 500 lnb

    I am getting 19.57 volts out of input 2 and 19.37 out of input 1 - should the voltages be the same?
  3. D

    Need Help troubleshooting Pro 500 lnb

    Yep, must be the receiver...did a hard reset and nothing on input 1. So does the "switch" in the lnb does not control what goes to the inputs but rather the switching from one sat to the other?
  4. D

    Need Help troubleshooting Pro 500 lnb

    Stealth: Did a direct drop from the DPP LNB, by passing the separator, into Input 1 and got nothing. Did the same into Input 2 and got both sats 119 and 110. Not sure how the switch works with DPP so would one side of the switch work and other not? OR, is it the receiver?
  5. D

    Need Help troubleshooting Pro 500 lnb

    Thanks, certainly is the least expensive route for now. I was wondering if there is a voltage test for the two inputs that might shed some light.
  6. D

    Need Help troubleshooting Pro 500 lnb

    I have a 522 receiver hooked to Pro 500 DPP (110 and 119) dish. I am only getting system 2 inputs, nothing on system 1. I replaced the separator but no go. Check switch shows: Input 1 Input 2 port 1 2 3...
  7. D

    Trouble Troubleshooting

    I have a superdish with 522 receiver. When re-installing dish (tree hit house, knocked dish out of alignment), I ran check switch and get a "NC" or no connection for 119 and 121 but do get "Conn" for the twin 110 lnb. Tried switching cables, ports, etc. but always get "NC" for 119 and 121...
  8. D

    Troubleshooting Question

    I have a superdish with 522 receiver. When re-installing dish (tree hit house, knocked dish out of alignment), I ran check switch and get a "NC" or no connection for 119 and 121 but do get "Conn" for the twin 110 lnb. Tried switching cables, ports, etc. but always get "NC" for 119 and 121...