Recent content by Edmund

Try the following: 1. av1 or av2 2. press and hold MUTE & SELECT for two blinks, release 3. enter 2 0 4 9 0 to get the volume: 1. av1 or av2 2. press and hold MUTE & SELECT, wait for two blinks, release 3. enter 9 9 3 4. press SELECT

The code you need is 32609, but it isn't preset into ANY directv remote, especially the rc71, which has no audio codes at all. It has to be sent to remote by the receiver.

Try the following: 1. dtv 2. press and hold MUTE & SELECT, wait for two blinks, release 3. enter 0 0 0 0 1 If it controls your HR44, the remote was NEVER in RF mode to begin with. Remember the Hr44 accepts both IR & RF at the same time, RF from Rc71, and IR from any Directv remote set to...

The rc66RBX will not control the hR44 in RF mode, don't waste your money.

Many keys on the rc65 remote are strictly for directv receivers, like the color keys. Press each key under the av1 or av2 device, if the light above the directv device goes on, that is a key only available to directv receivers no matter what dvd or blu-ray code is used. So you may not need a new...

Program av1 or av2 device with default IR code 00001: 1. av1 or av2 2. press and hold MUTE & SELECT, wait for two blinks, release 3. enter 0 0 0 0 1 Now enter the menu of the second receiver and switch like you did the first.

For directions, see this thread: http://www.avsforum.com/t/1458474/setting-up-multiple-directv-receivers-on-harmony-1100-in-same-room#post_22971599

The color keys on Directv remotes are strictly for directv receivers, no non-directv code in the remote has the color keys mapped, sorry.

If you read the description of the backlit remote, you see it's of the older type of remote, just has the wrong photo. There is no backlit rc71.

Sure, couple of ways to put it back into IR mode, easiest is to just program 00001 to the directv device: 1. dtv 2. press and hold MUTE & SELECT, wait for two blinks, release 3. enter 0 0 0 0 1

If the H10 remote is RF mode, use your H24 remote to put the receiver into RF mode as well, through the receiver menu, once receiver no longer responds to the H24 remote, do the following on the H10 remote: 1. dtv 2. press and hold MUTE & SELECT, wait for two blinks, release 3. enter 0 0 0 0 1...

After a 981 reset the directv device is programmed with code 00001 already. If still doesn't respond, than the receiver might be in rf mode: 1. dtv 2. press and hold MUTE & SELECT, wait for two blinks, release 3. enter 9 6 1 4. press CH UP 5. enter last 6 digits of Receiver ID #(RID), found on...

What?

Ask here: http://www.hifi-remote.com/forums/index.php?sid=8698080b21c65e0cf1db8b137c31b932

To control the HR44 by IR, the code in the RCA remote is 1377.