Recent content by hdayanan

bmp;

it looks like I have to mount my superdish on a pole or something, on the roof it gets blocked. the dia I think is 2 3/8 where can i buy a pipe of this spec? and also any suggestions on how deep to bury, any tips will be appreciated. I got the dish 500 119,110 working.. JASON, I did not get...

thank you, regards dan

jason, please mail it to xxxxxxxxxx regards

How do i go about doing this setup, first install 119 on superdish check switch to download the superdish software, then connect to 121 .....?? is there a installation guide for download? Should i set my superdish skew and elevation to 121 requirements, I do not have the manual can you...

You guys are amazing, thank you very much for all the help, will try out and post today. Have a Blessed Day, Kind regards Dan

I got a 105 superdish, i have already dish 500 with dp34 for the 119 and 110, can i just connect another cable to super dish and point at 121 and connect to dp34. if i stand in front of the dish which is the 121/105 connection?, any order the wires go into the switch? have a blessed day...

Finally solved, I had to replace the Dish pro adapter, even though both the adapters I had gave out good signal strength and on the surface looked fine, I replaced these with a working one from my friend and Bham it worked. I thank all of you who helped me out with advice and suggestions...

simplesimon, i checked the 301 for check switch results shows 1=119, 2=121, 3=110 could this be the problem? Foxbat, I have 2 adapters they are brand new, I do not know how to check them if they are working properly. i will borrow one which is working and try it out. I appreciate...

it was installed by the technician, I have to climb on roof top to check it, it works fine on the 301 and also before 3 days worked on the legacy receivers. I tried check switch now few mins back I get 119 no 110 and 121 and I got 110 121 yesterday but no 119. It looks like i get either 119 or...

yes, i did that and same problem, the 301 works fine at both the locations, the installer had the same problem when he installed it, but kept on trying and got it, he did not understand it also. I tried it with a 2700 and 3900 and same problem.

I had superdish installed recently, I have a legacy and a 301 receiver with dp34 switch. The 301 works fine when done check switch, the legacy 4900 does not detect 119, sometimes it does recognize the switch and works fine. I had removed the wires yesterday and now today it is again not...

I had superdish installed recently, I have a legacy and a 301 receiver with dp34 switch. The 301 works fine when done check switch, the legacy 4900 does not detect 119, sometimes it does recognize the switch and works fine. I had removed the wires yesterday and now today it is again not...