Recent content by ilyo3

Well VAN you must know Toronto elevation pretty good. I changed my elevation to 31 on the nose and moved the Dish a bit further south and BAM! I have 119 at 100% and 110 at 115%! Best signal strengths I ever got pointing a dish. Thanks to everyone for there help! STARGAZER: No tree's in...

Well I tried moving it right and left and I can hit 119 every time with great signal but can't find 110 at all. VAN: you are correct that I am at 27 elevation, so I will adjust the elevation tomorrow and let you know. Thanks.

Sorry just to clarify...I am looking AT the dish(in front of it) and am to move the dish slightly to the right. I should leave elevation and skew as it is? thanks for teh quick reply!

Just swapped out my two dishes for one new 20" with the DPP Twin. Set the elevation and skew appropriate to where I am (Toronto, Canada). I have 119 at 100%, but when I switch to check signal on 110..comes up 85% on wrong sat Echostar 129??? What have I done wrong. Sat calculators show...

Well I have an 18", a 20" and 24" dish and I can't use any of them...haha...my luck. So I will go get myself a DISH 500 20" Dish with the skew. Thanks everyone for all your help!

Okay turns out I had an old Direct TV 20" Dish with the correct arm. Got the Y adapter installed, hooked up to DPP LNB then connected to seperator and put both lines into my DISH 322. Problem is I can't seem to get a signal and was trying for quite some time. Noticed the Dish is a standard...

Yes, but then I would have 4 coax running to get 1 dual tuner receiver to work. If i can get 1 dpp on y yoke to work, I would then get 110 and 119 from 1 coax going in and using the seperator before the receiver...that is why I am soo interested in getting this to work! All help is...

110 and 119 using a DPP and Y yoke...

! I am in Toronto, so I am well within signal strength. I only have an 18" DISH and a 24" DISH and I do not believe you can get 2 sat's with an 18"..I heard the minimum is 20"..so that is why I bought the Y yoke and DPP LNB and am trying to make it work with the 24" DISH. Any help would be...

hack saw and welder??..the yoke is plastic? So here is another question...I have an 18" Dish, is the arm transferable to the 24" and can then receive 110 and 119?

I have a 24" dish with the standard dual LNB. I bought a Y yoke and Dish Pro Plus LNB. I went to install and realized the Y yoke does not fit on the arm of a 24" Dish...it only seems to fit on an 18" Dish. Is there anyway to convert a 24" dish into a Y set-up for a DPP as I prefer the larger...