Recent content by Jahbig

Having same problems in Southern California, no odd transponders.....A Dish Tech will be out Friday.......

YES....The same thing was said about XM satellite radio...started at $1.42 a share, now XM over $30.....a baby must learn to walk and talk, even after being shown and taught....

Sony XBR-800 "40" CRT: PQ; 4 out of 5...also the problems I see in VoOm, I've also seen worst in my cable provider--Adelphia...

It's also on my cable provider....... Adelphia....Not a Voom problem.

Done....

Sony XBR800 4 x 3 HDTV....DVI.....Excellent PQ..... Go Voom!

DVI Sony XBR800 "40" 4 x 3 CRT-1080i STB Owner set at Native P.S. Picture quality....EXCELLENT!!!....in LA area....on ALL channels....even though I have a faint vertical 3 inch white line moving from right to left, visible during dark scenes on my display... Very Minor....I've tried various...

I was only connected with the flat type phone cord on the STB end.....never knew the other end wasn't connected until I decided to investigate while the STB caller id function wasn't working....when I plug the other end to the phone wall jack box.....Lockups Galore.... Using the round high...

Use the round high speed DSL phone line with a DSL microfilter.....and hopefully that would limit frequent lockups to a minimum plus your caller ID function will now work. YOU'RE WELCOME...........

While trying to get the caller ID function to work,...I discovered the installer hadn't plug the phone line from the STB to the wall jack....Hmmmm....so I did the honors and LOCKUPS galore, before this no lockups....I hard booted 3 times in five minutes. So I changed the flat phone line to the...

Antennas Direct on the web...lots of antennas to choose from in different range categories. And forget about using the diplexers....have the cables run independently.....this will increase signal strength to your OTA antenna.

Try Cables To Go on the internet.

I don't know the type of TV you own, but try this: Lock in 1080i at the Output Resolution screen; press OK.....if the bottom left corner says "Press OK to continue in 1080i" you're at the right step. Remain at that screen. Open the red button door, push the red button until all four line...

I stand corrected; You MUST use Two diplexers are None. My installer used both; the diplexorS and the power inserter. When I ask him to remove the diplexerS and run each cable separately, OTA signal shot up, channels stablized and PQ increased.

Those are both diplexers; you'll only need one. How do you get power to your OTA amplifer? I'm only using the power inserter to power up the amplifier in my OTA antenna. No diplexer; the cables are connected directly to the Sat connection from the Voom dish; and from the OTA, to the inserter...